The Chevrolet Corvette C8 introduced two major changes: a mid-mounted engine and a dual-clutch automatic as the only transmission. According to the review, developing both a manual and an automatic transaxle for the mid-engine layout was not in General Motors’ budget, so executives prioritized comparison-test performance over a small group of manual enthusiasts.
Tremec, the supplier behind the six-speed manual used in GM performance models including the Cadillac Blackwing cars and the discontinued Camaro, has built a manual C8 development vehicle. The company invited a journalist and several potential customers to Motorsports Gateway, a private track outside Howell, Michigan, to sample its transmissions. The vehicle provided was a Peitz Performance C8 race car fitted with Tremec’s new manual gearbox.
A track build, not a showroom conversion
The test car was a dedicated track build with a full cage and harness. It had no interior fit and finish, and the shifter emerged where the storage cubby and automatic selector normally sit. The seating position had almost no adjustment; the reviewer, who is 5-foot-7, could not reach the floor or brace against the tunnel in corners, making heel-and-toe downshifts awkward. He therefore did not push the car hard on a green track on a November afternoon.
The mechanical installation was more straightforward than the interior suggests. The tunnel had to be cut to fit clutch-pedal hardware, but the manual transaxle otherwise occupied the same space as the stock dual-clutch unit. No special mating hardware was required, and the C8’s pedal box had enough room for a clutch pedal. Even with three pedals, the footwell felt roomier than a previous-generation Camaro’s, according to the review.
Remote shifter changes the feel
Because the C8’s transmission is behind the driver, the shifter is remotely mounted and linked by cables. That makes operation less precise and less snick-snick than the front-engine TR-6060 six-speed, and also less notchy. Some drivers may prefer the smoother action; others may miss the more mechanical feel of the front-engine installation. The only ways to recover that feel would be to move the engine forward or the shifter rearward, neither of which is a simple change for the C8 layout.
The bigger obstacle may be cost. The gearbox alone is priced at about $75,000, and combining it with a Corvette puts a manual C8 build in the same price range as a showroom Z06, according to the report. Tremec says the price should fall as volume rises. The supplier also says OEMs are interested, not necessarily or exclusively GM, and that other automakers have asked for a high-torque manual transaxle. No customers were named.
The development car therefore demonstrates that a manual C8 is technically feasible and that the driving experience carries trade-offs. It does not establish that Chevrolet will offer one. For now, the car is a supplier demonstration: a track-only, single development vehicle used to show the gearbox and gauge interest.
