Custom Manufacturing

Northwestern's DIAL Method Prints Thick Functional Inks at Voxel Resolution

A hybrid process spreads particle-filled inks into 25-micron sheets and uses a 405 nm projector to crosslink selected regions at 50-micron planar resolution.

Hanna VirtanenNovember 9, 20265 min read5 views
A conceptual illustration shows a slot-die and doctor blade spreading particle-filled ink into a thin sheet while a violet projector crosslinks selected areas, with lattice and chain-mail geometries nearby.

Researchers at Northwestern University have developed a hybrid 3D printing method called direct ink additive lithography, or DIAL, that is designed to print thick, particle-filled extrusion inks at speeds and resolutions closer to those of light-based processes. The work, led by Pranav Kaarthik, was published in Science Advances.

The approach targets a trade-off between two established techniques. Digital light processing depends on low-viscosity, weakly scattering resins, while direct ink writing can handle functional yield-stress inks but is slowed by filament deposition and constrained by nozzle diameter. DIAL combines ink extrusion with projected light instead of choosing one route.

For each layer, a slot die extrudes ink onto the substrate, and a doctor blade scrapes the material into a sheet as thin as 25 microns. A 405-nanometer projector then moves over the sheet and crosslinks selected regions. Uncured ink remains in place and acts as support. Because light passes only through a thin sheet, opaque and heavily filled inks remain printable. The projector's 50-micron pixel pitch sets the planar resolution.

Using a model ink made from a polyurethane-based resin thickened with fumed silica, the team printed a 60 mm by 40 mm log-pile structure in 30 minutes, compared with 124 minutes for direct ink writing. It also produced fins about 150 microns thick. Rastered projection across overlaid ink sheets yielded a multimaterial lattice four times the projector's illumination area.

The researchers also demonstrated interlocking chain mail with struts about 250 microns thick, 15 gyroid structural electrolyte lattices from an ionogel ink in a single 15-minute run, and hydrogel cell-culture inserts containing 0.5-mm-deep inverted pyramids. They described the reported print times as conservative because tool changes had not been tuned for speed. They also said the absence of suction and peel forces found in vat-based printing should make it easier to expand build area and volume.

Ryan Truby, June and Donald Brewer Junior Professor of Materials Science and Engineering at Northwestern, said manufacturers have had to choose between needed materials and desired printing speed, resolution and scale. He said DIAL provides a foundation for removing that compromise. Truby also said that because DIAL can print many complex functional parts at once, the team sees a path toward scaling it from the lab to larger-volume manufacturing of architected materials for robotics, aerospace, healthcare and other applications.

Kaarthik and Truby are listed as coinventors on a U.S. provisional patent application. Funding came from the National Science Foundation, the Air Force Office of Scientific Research and Northwestern's McCormick School of Engineering.