Researchers in China have identified progressive wear of screen-mesh knuckles as a main cause of screen-printing-induced degradation in copper-plated silicon heterojunction (HJT) solar cells and have proposed an emulsion buffer layer to limit the damage.
Screen printing is widely used for solar cell metallization, but in HJT cells the process can affect sensitive passivating contacts. The issue is especially important for copper-plated HJT designs, which aim to cut metallization costs and reduce silver use.
Why photoresist printing differs
Corresponding author Lang Zhou told pv magazine that photoresist screen printing differs from conventional silver-paste printing. Silver paste screens have openings covering only 2–5% of the area, with emulsion preventing direct mesh-wafer contact elsewhere. Full-area photoresist coating typically uses a screen without emulsion coverage, so the mesh contacts the wafer extensively during each cycle.
Previous production data showed conversion efficiency falling from 26.2% to 25.7% over 15,000 consecutive printing cycles. Open-circuit voltage and fill factor accounted for most of the loss, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Wear and recombination
Using three-dimensional confocal microscopy, the researchers traced the degradation mainly to progressive wear of the mesh knuckles. As knuckles wore, their contact area with the wafer increased, raising mechanical stress on the passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements indicated higher recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
To reduce direct contact, the team developed an emulsion buffer layer and evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%.
Trade-off in screen design
The results revealed a trade-off between mechanical protection and photoresist coating uniformity. Higher emulsion coverage reduced damage but impaired ink distribution. A 4.7% coverage ratio provided the best balance: after 10,000 printing cycles, minority carrier lifetime degradation was limited to 0.41% while coating uniformity remained relatively good.
The researchers attributed the improvement to the emulsion layer preventing direct contact between the mesh and wafer, reducing cumulative mechanical damage to the passivation layers. Zhou said the findings show that a relatively simple screen-design modification can substantially mitigate printing-induced degradation and offer a practical route to improving manufacturing reliability for copper-plated HJT cells.
The work was published in Solar Energy as “Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells.” The study adds to growing interest in copper metallization for HJT. In April 2026, Nankai University researchers reported a silver-free HJT cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating, addressing adhesion, contact resistance and stability at the ITO interface. Separately, Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT cell, a relatively small penalty versus its silver-metallized counterpart, while a cell with silver-copper paste on the front and silver contacts on the rear reached 23.95%.
Those results underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance are still needed.
