Automotive Accessories

Builder Flips Differential to Create Budget Rear-Only Portal Axle for Jeep XJ

Zeph Gage combines a Ford 9-inch housing, Humvee geared hubs and a flipped differential to add clearance at a fraction of typical portal-axle cost.

Mei-Lin ChenNovember 17, 20265 min read2 views
A cutaway workshop view shows a rear axle with a flipped differential, geared hubs and custom brackets, illustrating the clearance-focused conversion.

Zeph Gage has built a rear-only portal axle for a Jeep XJ, using a flipped Ford 9-inch differential, Humvee geared hubs and custom adapters to deliver much of the clearance benefit of far more expensive hardware. The conversion is not an off-the-shelf kit; it depends on fabrication work that turns familiar low-pinion parts into a high-clearance arrangement.

Portal axles are conceptually simple but costly. Instead of letting axle shafts and drivetrain components hang below the vehicle, they place a stack of gears behind each driven wheel. That lets the axle tubes sit higher and leaves little hardware below the frame line. With tall tires, the result is substantially more ground clearance. A typical set from companies such as 74Weld costs about $20,000, while the axle on Gage's Jeep costs one-fifth of that.

A flipped differential and Humvee hubs

Gage's assembly combines a Ford 9-inch axle housing, geared hubs from a Humvee and a set of Jesse Haines Fabrication HMMWV portal adapters. Two-gear portals like the Humvee's reverse the rotation of the input shaft. To make that work with the Ford 9-inch, Gage flipped the differential upside down so the driveline spins in the correct direction. A Yukon Gear and Axle third member is then bolted to the differential, creating what amounts to a budget high-pinion unit from low-pinion parts turned on their head.

The arrangement does more than add about six inches of clearance. It also retains full shock travel—a difficult goal with portal axles—and reduces stress on the differential itself. Gage expects the result to be effectively bulletproof, though that is a builder's assessment rather than a verified durability result.

Why the front axle stays conventional

Installing a portal axle only at the rear may look unusual, but it is a common approach in the remote-control rock-crawler scene. By keeping the solid front axle, Gage avoids the packaging constraints that often arise when portal axles are fitted to a vehicle that never had them from the factory. He also avoids restricting shock travel to satisfy those constraints, and the ride height does not become absurdly high. The layout is intended to balance clearance, suspension travel and practicality.

This is not a bolt-on solution. Gage carried out substantial custom fabrication, including homemade brackets, custom-tapped plates and a two-piece brake rotor paired with a Ford Fusion caliper. The Fusion hardware was chosen partly because it offers an integrated electric parking-brake solenoid and partly for clearance.

The finished Jeep XJ can drive over a five-gallon bucket and still have several inches of spare clearance, according to the build details. That means the rear end should be less likely to hang up on obstacles that the front can steer around. The project required considerable thought and custom work, but it shows how a rear-only portal setup can add useful capability without the cost of a conventional pair.